We want you to keep him happy with his reading, scan the code, go to the phone.
Add to your site
We are pleased to offer you that you can embed this in the article on your site.
Gather all the material. The extra TV
or VCR/DVD combo will be used as your channel selector. Also make sure that you get a sizable amount of digital input cables (Red
Yellow tipped cables; often seen on modern digital devices such as video game inputs.) so that you can run them from your channel turner to the projector for placement of your devices.Place your projector where you would like it to set. Select turner device. If it is a TV
take the input cables and connect them to the "out" video cable slots on the back of the TV(Red
then connect the other side of the cable to the video inputs on the data projector. If this is done properly one it has been set up the projector will display what is on the TV.If you are using a digital cable box it is even simpler. Just connect the input cables from the video "out" slots on the digital cable box
and the input video "in" slots on the projector. If you are using the VCR/DVD combo it works the same as the TV. Find the video "out" slots connect the cables to these slots (Once again they are Red
and Yellow; will have the word "out" underneath them)
and then connect the other end of the cables to the projector "in" cable slots.Connect your coaxial cable to your turner device. If it is your TV
the coaxial plugs into your TV as if you are watching cable on your TV. The digital cable box will have a port for the coaxial cable and that is where you plug it in at. The VCR/DVD combo has a coaxial "in". Once the coaxial is in you should be able to tune to different channels via the cable box
or VCR/DVD combo. Using the menu on your digital cable box
or VCR/DVD combo; you can channel search to set up your channels.Note that if you are using a TV
the projector will only show what the TV shows. So if the TV is off
then the projector will give you a blank screen.Make sure that the projector is set to the video input signal so that will pick up the images. Do this by pressing the input button on the projector
or its remote until it shows the image or an indication of the input cable channel.Connect a sound source. Most projectors that are cost efficient do not have high quality sound. If you have a sound source that you would like to use
such as a surround sound
simply unplug the RED and WHITE cable from the project (NOT FROM YOUR TUNING DEVICE) and plug them into the RED and WHITE audio "in" slots on the separate sound source. If you are using a surround sound
the slots will be provided and all you would have to do after plugging it in would be to turn on the surround sound
select the audio channel
and then the sound will come through the speakers of your surround of the TV that your watching.